According to the filling principle, the filling machine can be divided into atmospheric filling machine, pressure filling machine, liquid filling machine, oil filling machine, paste filling machine, sauce filling machine, granular slurry filling machine , Powder filling machine, vat water filling machine and vacuum filling machine. Atmospheric filling machine is filling by the weight of the liquid under atmospheric pressure. This type of filling machine is divided into two types: timing filling and constant volume filling, which are only suitable for filling low-viscosity and gas-free liquids such as milk, liquor, mineral water, etc. Filling is carried out at higher than atmospheric pressure, and it can be divided into two types: one is the pressure in the liquid storage cylinder is equal to the pressure in the bottle, and the liquid flows into the bottle by its own weight. This is called equal pressure filling. ; The other is that the pressure in the liquid storage cylinder
There are indeed many types of filling machines. When the classification is not very strict, we can call them according to the material. For example, we call the chili sauce filling machine for filling chili sauce, and we call the edible oil filling machine for filling edible oil. Installed. In addition, we have other classification methods Classified according to the principle of operation. There are flow meter type filling machine, plunger type filling machine, self-flow type filling machine and so on. Classified according to the degree of automation. There are semi-automatic filling machines, automatic filling machines, filling lines, etc. According to the material form classification. There are paste filling machines, liquid filling machines, powder filling machines and so on.
With regard to the three common faults and cause analysis of the belt of the capping machine, I hope that it can help everyone quickly find out the cause and make adjustments when encountering a belt fault, so that the belt can run better! One: the bottle is dumped 1) The center of the belt and the center of the capping wheel are not on the same straight line 2) The speed of the conveyor belt and the speed of the capping machine belt are not synchronized 3) The belt is too loose or the tightening torque is large 4) The upper and lower distance of the belt is too small 2: The cap is not tightened 1) The bottle goes too fast when screwing the cap 2) The belt tightening torque is too small or the rubbing wheel speed is too slow